Sanyo VHR-VT821A Service Manual page 14

NOTE
1. When you install the Loading Arm S Unit, Loading Arm
T Unit and Main Loading Gear, align each marker.
(Refer to Fig. 2-16-B)
Main Loading Gear
Marker
Loading Arm T Unit
2-17: CLUTCH ASS'Y/RING SPRING/CLUTCH LEVER/
CLUTCH GEAR (Refer to Fig. 2-17-A)
Remove the Polyslider Washer 1.
1.
2. Remove the Clutch Ass'y and Ring Spring.
3. Remove the Clutch Lever.
4. Remove the Coupling Gear, Coupling Spring and
Clutch Gear.
Coupling Gear
Coupling Spring
Clutch Gear
NOTE
1. In case of the Clutch Ass'y installation, install it with
inserting the spring of the Clutch Ass'y into the dent of
the Coupling Gear. (Refer to Fig. 2-17-B)
DISASSEMBLY INSTRUCTIONS
Marker
Loading Arm S Unit
Fig. 2-16-B
1
Clutch Ass'y
Ring Spring
Clutch Lever
Fig. 2-17-A
Clutch Ass'y
Coupling Gear
Fig. 2-17-B
2-18: CASSETTE GUIDE POST/INCLINED BASE S/T
UNIT/P4 CAP (Refer to Fig. 2-18-A)
1. Remove the P4 Cap.
Unlock the support 1 and remove the Cassette Guide
2.
Post.
3. Remove the Inclined Base S Unit and Inclined Base T
Unit.
Inclined Base S
Unit
NOTE
1. Do not touch the roller of Guide Roller.
2. In case of the P4 Cap installation, install it with parallel
for "A" and "B" of Fig. 2-18-B.
3. In case of the Cassette Guide Post installation, install
correctly as the circled section of Fig. 2-18-C.
P4 Cap
[OK]
Cassette Guide Post
[NG]
Cassette Guide Post
14
Cassette Guide Post
1
Inclined Base T
Unit
"A" "B"
Cassette Opener
P4 Cap
Fig. 2-18-A
Fig. 2-18-B
Fig. 2-18-C