Connecting Speakers - JVC CA-MXJ75R Instructions Manual

AM (MW/LW) antenna
1 2
ANTENNA
GND
AM LOOP
AM EXT
FM 75
COAXIAL
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
2
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
loop antenna must remain connected.)
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.

Connecting Speakers

You can connect a pair of front speakers, one center speaker,
a pair of rear speakers, and one subwoofer.
3
To connect front speakers
Vinyl-covered wire
(not supplied)
1
2
3
– 7 –
1
Red
SPEAKERS
Speaker
RIGHT
cord
Black
Right
speaker
Press and hold the clamp of the speaker
terminal on the rear of the unit.
Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
2, 3
Speaker
LEFT
cord
Left
speaker