Miele T 8929 WP Operating Instructions Manual page 44

Problem solving guide
Problem
There are humming
noises.
The display is dark.
The programme
selector is not lit up.
The Start/Stop button
light flashes slowly.
The Start/Stop
indicator light
flashes/does not flash.
A programme cannot
be started.
Power cut.
The display is in a
different language.
The interior drum
lighting is not
switched on.
44
Possible cause
The compressor is
operating.
The display has
switched off
automatically to save
energy (Standby
mode).
The light of the
programme selector
goes out when
selecting Settings J.
The flashing indicates
that a programme can
be started.
There is no immediate
cause.
When power is restored to the tumble dryer after a
power cut, the programme will continue automatically.
A different language
has been selected.
The lighting switches
off automatically (to
save energy).
Remedy
None. These noises are quite
normal and do not indicate a
fault.
The display will light up when
one of the buttons is pressed.
After the programme has
started, the flashing will
change to a constant light.
– Is the dryer switched on?
– Is the mains plug plugged
in?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
– If you cannot remedy the
problem, there is a fault.
Call Miele.
Set the language you want.
The flag symbol J will guide
you.
– Switch the dryer off and
then on again.
– If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.