Miele T 8929 WP Operating Instructions Manual page 41

Problem
Clean out airways
E
appears after a
programme is
cancelled.
The laundry is not
completely dry.
A prompt which has
not been described
previously appears in
the display.
* To delete the fault message: Switch the dryer off and then on again.
Possible cause
The cool air intake
panel at the front of
the dryer is covered,
e.g. by a laundry
basket.
The temperature in
the room has risen
sharply.
The drying
programme has been
interrupted by a
cooling phase to
protect the heat
pump from
overheating.
Too much fluff has
accumulated.
A programme cannot
be started while there
is a fault message in
the display.
Problem solving guide
Remedy *
– Remove the laundry basket
or other objects.
– Open a door or window
while the machine is in
operation for increased air
flow.
– Start the programme again
once the room has cooled
down.
Check and clean the surfaces
of the fluff filters and the fine
filter.
Carefully vacuum up any dust
or lint on the cooling fins which
may be causing a blockage
from the heat exchanger unit at
the bottom left (see "Cleaning
and care").
– Note what is shown in the
display.
– If a programme still cannot
be started, call the Miele.
41