Table of Contents
Advertisement
O
perations
Getting ready
The mop pad may have already come
attached to the swivel head. If not atta-
ached, follow steps 1A and 1B below.
1. Attach mop pad.
A. Set swivel head in mop pad, making
sure toggle is located on the back.
B. Tighten mop pad by pulling on elastic
cord while pressing on toggle
2. Fill the water tank.
A. Remove the tank by lifting straight up
and away from the unit. B. Unscrew
the cap at the bottom of the water
tank and remove the insert assembly.
C. Fill the water tank with water. For
best results, water should be at room
temperature.
D. Replace the insert assembly and cap,
tighten until snug.
E. Replace the water tank by lining up
the vertical guides and gently sliding it
back into place.
3. Twist the quick release cord wrap
clockwise to unwrap the power cord
completely, make sure both switches are
in the "OFF" position and plug it into a
120-volt grounded outlet as described on
the Important Safety Instructions page.
4. The ready light will illuminate when the
Spiffy Steam Mop is ready for use.
NOTE: Upon first use of the Spiffy
Steam Mop or first use of the filter,
the pump may make a "knock-
ing" sound while the fliter fills with
water. This is normal and should
not last longer than 30 seconds.
Continue to depress the trigger until
the knocking subsides.
www.pawsitivelycleanpet.com
Tip:
To prevent damage to the
machine, do not attempt to use
your Spiffy Steam Mop without
water in the tank.
1A.
2A.
2E.
8 0 0 . 2 3 7 . 7 6 9 1
1B.
2B.
7
Advertisement
Table of Contents
