Front Brake - KYMCO People GT 300i Service Manual

14. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK

FRONT BRAKE

BRAKE MASTER CYLINDER
REMOVAL
Remove the handlebar covers. ( 2-3)
Drain the brake fluid from the hydraulic brake
system.
Disconnect the
connector.
Remove the brake fluid tube bolt.
Remove two bolts attaching the brake master
cylinder
Remove the brake master cylinder.
• When servicing the brake system, use
towels to cover rubber and plastic parts
and coated surfaces to avoid being
contaminated by brake fluid.
• When removing the brake fluid tube
bolt, be sure to plug the tube end to
avoid brake fluid leakage.
DISASSEMBLY
Remove the brake lever bolt and the brake
lever.
Remove the piston rubber cover and snap
ring from the brake master cylinder.
Remove the washer, main piston and spring
from the brake master cylinder.
Clean the inside of the master cylinder and
brake reservoir with brake fluid.
front stop switch wire
Snap Ring Pliers (Close)
Master Cylinder
Snap Ring
People GT 300i
Snap Ring
Spring
Main Piston
Rubber Cover
14-8
Holder