Updating (Flashing) Bios From Your Operating System; Recovering From A Post/Bios Update Failure - Lenovo ThinkCentre 7258 User Manual

2. Turn the computer off and back on again. The update begins.
3. When prompted to change the serial number, press Y.
4. Type in the 20-character serial number of your computer and then press Enter.
5. When prompted to change the machine type/model, press Y.
6. Type in the 20-character machine type/model of your computer and then press
7. Follow the instructions on the screen to complete the update.

Updating (flashing) BIOS from your operating system

Note: Due to the constant improvements made to the Web site, Web page content
1. Go to:
2. Locate the downloadable files for your machine type as follows:
3. Print these instructions. This is very important because they are not on the
4. Click Back to return to the list of files. Carefully follow the printed instructions

Recovering from a POST/BIOS update failure

If power to your computer is interrupted while POST/BIOS is being updated (flash
update), your computer might not restart correctly. If this happens, perform the
following procedure commonly called Boot-block Recovery.
10. Turn on the computer and the monitor. Insert the POST/BIOS update (flash)
414
Hardware Maintenance Manual
Enter.
(including the links referenced in the following procedure) is subject to
change.
http://www.lenovo.com/support
a. In the Enter a product field, type your machine type and click Go →
Continue → Downloads and drivers.
b. Under the BIOS category, click Flash BIOS update.
c. Click the TXT file that contains the installation instructions for the flash
BIOS update (flash from the operating system version).
screen after the download begins.
to download, extract, and install the update.
1. Turn off the computer and any attached devices, such as printers, monitors,
and external drives.
2. Unplug all power cords from electrical outlets, and remove the computer
cover.
3. Access the system board.
4. Locate the Clear CMOS/Recovery jumper on the system board. Refer to
"System board connectors" on page 124.
5. Remove any cables that impede access to the Clear CMOS/Recovery jumper.
6. Move the jumper from the standard position (pin 1 and pin 2) to pin 2 and
pin 3.
Note: If the system board has only two pins for clearing the CMOS, add a
jumper to the two pins.
7. Reinstall any PCI adapter card if removed.
8. Reconnect any cables that were disconnected and reinstall the computer cover.
9. Reconnect the power cords for the computer and monitor to electrical outlets.
disc into the optical drive.