Sharp SH002 Manual Manual page 57

Symptom
Cannot hear the other
● Is the earpiece volume too low?
party.
● Is
When making a call, a
beeping sound is heard
from the earpiece and
a connection cannot be
● Is the wireless line busy or is the phone
established.
● Is manner mode turned on?
The incoming LED
flashes but the ring
● Is
tone does not play.
● Is the battery pack attached properly?
● Are the plug and connector of the AC
Cannot charge the
battery pack.
● Is the remaining battery level over 80%
When the camera is
● Is a finger or other object covering the
activated, no subject is
displayed.
• For more detailed information, visit the following au troubleshooting sites:
- From an au cell phone: M
オンラインマニュアル (Online Manual)
- From a PC: http://www.kddi.com/customer/service/au/trouble/kosho/index.html
Possible Cause
(out of range indicator)
displayed? Or are you in a location
where the signal is too weak?
you are calling on another line?
(ring tone off indicator) displayed?
adapter inserted properly?
or the temperature too high/low?
camera lens?
auお客さまサポート (au Customer Support)
⇒ ⇒
au one Top
故障診断Q&A (Troubleshooting FAQ)
⇒
Remedy
Press A during a call to increase the
earpiece volume.
Move to a location where
indicator) is no longer displayed. Also
check the Area Setting.
End the call and try again later.
Hold down H for at least one second to
turn off manner mode.
Increase the volume of the incoming call
ring tone.
Attach the battery pack properly.
Insert the plug and connector firmly.
Use the AC adaptor to charge the battery
pack.
Check the position of the camera lens and
remove the obstacle.
⇒
Page
22
(out of range
14, 25
20
22
23
9
10
3, 10
37
55