Sony CCD-TRV128 Service Manual page 90

After charging the battery
The CHG (charge) lamp turns off when the
battery is fully charged. Disconnect the AC
Adaptor from the DC IN jack.
To remove the battery pack
BATT (battery)
release button
1
Lift up the viewfinder.
2
Set the POWER switch to (CHG) OFF.
3
Slide the battery pack out in the direction
of the arrow while pressing the BATT
(battery) release button down.
b Note
• If you do not use the battery pack for a long time, use
up the battery pack completely before storing it. See
page 83 about storage of the battery pack.
To check the remaining battery – Battery
Info
DSPL/BATT INFO
OPEN
POWER switch
POWER switch
You can check the battery's current charge level
and its current remaining recording time both
during charging or when the power is turned off.
1
Set the POWER switch to (CHG) OFF.
2
Press OPEN and open the LCD panel.
3
Press DSPL/BATT INFO.
The battery information appears for about 7
seconds.
Keep the button pressed to view it for about
20 seconds.
BATTERY INFO
BATTERY CHARGE
0% 50%
REC TIME AVAILABLE
LCD SCREEN:
VIEWFINDER: 112 min
A Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B Approximate possible recording time
using the LCD panel.
C Approximate possible recording time
using the viewfinder.
Charging time
Approximate number of minutes required when
you fully charge a fully discharged battery pack
at 25°C (77°F). (10 – 30°C (50 – 86°F)
recommended.)
Battery pack
NP-FM30 (supplied)
NP-FM50
NP-QM71/QM71D
NP-QM91/QM91D
Recording time when recording with the
LCD screen on
Approximate number of minutes available
when you use a fully charged battery pack at
25°C (77°F).
LEVEL
100%
81 min
145
150
260
360
,continued
13
Getting started