Lennox MPDT33RNM Installation Instructions Manual page 3

Merit plus series mpd direct-vent gas fireplaces
Table of Contents

Advertisement

LENNOX HEARTH PRODUCTS • MERIT PLUS
WARNING
I m p r o p e r
i n s t a l l a t i o n ,
adjustment, alteration, service
or maintenance can cause injury
or property damage. Refer to
this manual. For assistance or
additional information consult
a qualified installer, service
agency or the gas supplier.
WARNING
Failure to comply with these
installation instructions will
result in an improperly installed
and operating appliance, voiding
its warranty. Any change to this
appliance and/or its operating
controls is dangerous.
WARNING
Clothing or other flammable
material should not be placed
on or near the appliance.
AVERTISSEMENT
On ne devrait pas placer de
vêtements ni d'autres matières
inflammables sur l'appareil ni à
proximité.
WARNING
Any safety screen or guard
removed for servicing the
appliance must be replaced
prior to operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l'entretien de
l'appareil doit être remis en
place avant de mettre l'appareil
en marche.
WARNING
Improper installation or use of
this appliance can cause serious
injury or death from fire, burns,
explosion or carbon monoxide
poisoning.
DIRECT VENT GAS FIREPLACES (MPD33/35/40/45) • INSTALLATION INSTRUCTIONS
®
WARNING
Failure to position the parts in
accordance with these diagrams
or failure to use only parts
specifically approved with this
appliance may result in property
damage or personal injury.
AVERTISSEMENT
Risque de dommages ou de
blessures si les pièces ne sont
pas installées conformément à
ces schémas et ou si des pièces
autres que celles spécifiquement
approuvées avec cet appareil sont
utilisées.
Note: Installation and repair should be
done by a qualified service person. The
appliance should be inspected before use
and at least annually by a professional
service person. More frequent cleaning
may be required due to excessive lint from
carpeting, bedding material, etcetera. It
is imperative that control compartments,
burners and circulating air passageways of
the appliance be kept clean.
Remarque: L'installation et la
réparation devrait être confiées à un
technicien qualifié. L'appareil devrait
faire l'objet d'une inspection par un
technicien professionnel avant d'être
utilisé et au moins une fois l'an par la
suite. Des nettoyages plus fréquents
peuvent être nécessaires si les tapis,
la literie, et cetera produisent une
quantité importante de pous-sière. Il
est essentiel que les compartiments
abritant les commandes, les brûleurs
et les conduits de circulation d'air de
l'appareil soient tenus propres.
Do not use these appliances if any part
has been under water. Immediately
call a qualified, professional service
technician to inspect the appliance
and to replace any parts of the control
system and any gas control which have
been under water.
Ne pas utiliser cet appareil s'il a été
plongé, même partiellement, dans
l'eau. Appeler un technicien qualifié
pour inspecter l'appareil et remplacer
toute partie du système de commande
et toute commande qui a été plongée
dans l'eau.
Only trim kit(s) supplied by the
manufacturer shall be used in the
installation of this appliance.
Seules les trousses de garniture
fournies par le fabricant doivent être
utilisées pour l'installation de cet
appareil.
These appliances comply with National
Safety Standards and are tested and listed
by OMNI-Test Laboratories, Inc. (Report
No. 116-F-13-4) to ANSI Z21.88-2009 (in
Canada, CSA-2.33-2009), and CAN/CGA-
2.17-M91(R2009) in both USA and Canada,
as vented gas fireplace heaters.
Both millivolt and electronic versions of
these appliances are listed by OMNI-Test
Laboratories for installation in bedrooms
and Manufactured Homes.
Misc. Codes / Standards
The Installation must conform to local codes
or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1-2009
/ NFPA 54—latest edition (In Canada, the
current CAN/CSA-B149.1 installation code).
The appliance, when installed, must be
electrically grounded and wired in accordance
with local codes or, in the absence of local
codes, with the National Electrical Code,
ANSI/NFPA 70—latest edition, or the
Canadian Electrical Code, CSA C22.1—
latest edition.
Provide adequate clearances around
air openings and adequate accessibility
clearance for service and proper operation.
Never obstruct the front or back openings of
the appliance.
These appliances are designed to operate
on natural or propane gas only. The use
of other fuels or combination of fuels will
degrade the performance of this system and
may be dangerous.
These fireplaces are designed as supplemental
heaters. Therefore, it is advisable to have an
alternate primary heat source when installed in
a dwelling.
These appliances must not be connected to a
chimney or flue serving a separate solid fuel
burning appliance.
Both millivolt and electronic systems can be
operated during a power outage, and feature
manually operated hi-low flame control. The
BTU Input for these appliances is shown in
Table 1.
Input Rate (BTU/HR)
Models
Nat. Gas
17,500 high
MPD33
11,700 low
20,000 high
MPD35
12,800 low
27,000 high
MPD40
18,500 low
29,000 high
MPD45
20,500 low
Table 1: Input (BTU/HR) Gas Valves
(Millivolt and Electronic)
Prop. Gas
17,500 high
14,000 low
20,000 high
15,200 low
27,000 high
21,500 low
29,000 high
22,500 low
3

Advertisement

Table of Contents
loading

Table of Contents