Eight Tack Abel Nstallation - Paramount Fitness XL2 Series Installation & Assembly Manual

11. Be sure that the dimension from under the
CABLE BOLT to the bottom of the CABLE NUT
DOES NOT exceed 1-3/8" (35mm) as shown.
With the cable tension properly adjusted,
securely tighten the CABLE NUT.
12. Lubricate the guide rods using a Teflon
spray lubricant. Paramount recommends
TriFlow brand.
13. Reassemble the REAR SHROUD and the
TOP CAP assembly.
W S L
EIGHT TACK ABEL
Locate the weight stack labels packed with your machine order. For your reference, a list of weight
stack labels and their corresponding part numbers is shown below. (KG labels available on request)
Weight Stack
(12) x 10 lb.
Label Part #
For the 130 lb./190 lb. weight stacks, discard the last 4 stickers on the label strip. Verify that the
correct weight stack is properly installed on the machine.
Label Installation:
1. With a clean, dry cloth, wipe the front surface
of the weights with rubbing alcohol and allow
the weights to dry completely. Make sure that
there is no lint on the surface.
2. Remove the backing from the label. Align the
top edge of the label with the top edge of the
weights and the side of the label with the
outside edge of the selector pin holes.
3. Verify that the label strip is straight and
remove the liner. As the liner comes off the
label, press and rub each label into place.
4. IMPORTANT! DO NOT attempt to "test" the
integrity of the labels after they have been
installed. The adhesive on the labels requires
72 hours to cure.
I
NSTALLATION
130 lb. 190 lb.
(12) x 15 lb. (16) x 10 lb.
B2170 B2172
I
NSTALLATION AND
CABLE
BOLT
CABLE
NUT
VERIFY LABELS B2141B
AND S630 ARE INTACT
170 lb. 250 lb.
(16) x 15 lb. (20) x 10 lb.
B2170 B2172
Individual
Labels
Liner
Align with
outside
edge of
pin holes
13
A
SSEMBLY
1-3/8" MAX.
[35 mm]
210 lb. 310 lb.
(20) x 15 lb.
B2071 B2073
.