Rheem 701 Owner's Manual And Installation Instructions page 13

iii) Activating Calibration Reset Mode Continued,
5. Press and release the (✓) button to activate calibration mode. „Error Codes‟
will be displayed on the screen with any error codes listed below.
6. Press and release the (✓) button to revert back to the main menu „Calibrating
Do Not Interrupt‟ will be displayed on the timer screen and the unit will
recalibrate the boiling water temperature. When calibration is complete the
timer display will automatically revert back to the main menu.
iv) Activating Temp Override
Temperature override allows the installer to set the calibrated temperature to perform
a fast calibration when the unit is operated for the first time, or to change the boiling
water temperature to a selectable value from 70ºC – 99ºC.
1. Press and release the (P) button until „Service‟ is displayed flashing on the
screen.
2. Press and release the (
displayed on the screen with any error codes listed below
3. Press and release the (▲) button until „Temp override‟ is displayed on the
screen.
4. Press and release the (
(or preset) boiling water temperature will be displayed flashing on the screen.
5. Press and release the (Up) button until the desired setting appears flashing on
the screen. Each consecutive press and release of the (Up) button increases
the boiling water temperature setting in 1º increments from 70ºC to a
maximum of 99 ºC.
6. Press and release the (
the screen.
7. Press and release the (
timer screen will revert back to the main menu, „Calibrating Do Not Interrupt‟
will be displayed on the timer screen and the unit will recalibrate the boiling
water temperature to the new selected temperature. When calibration is
complete the timer display will automatically revert back to the main menu.
v) Accessing Software Version
1. Press and release the (P) button until „Service‟ is displayed on the screen.
2. Press and release the (✓) button to confirm selection. „Error Codes‟ will be
displayed on the screen with any error codes listed below.
3. Press and release the (▲) button until „Software Version‟ is displayed on the
screen.
4. Press and release the (✓) button to confirm selection. The software version
will be displayed on the screen. The top digits refer to the timer software
version and the lower digits refer to the controller software version.
5. Press and release the (X) or (✓) button to revert back to the service menu.
„Error Codes‟ will be displayed on the screen.
6. Press and release the (X) or (✓) button to revert back to the main menu.
button to confirm selection. „Error Codes‟ will be
✓)
✓
) button to confirm selection. The current calibrated
) button. „Are You Sure‟ will be displayed flashing on
✓
✓
) button to confirm selection after which time the
13