Setting Nac 800 Properties - HP 800 User Manual

System Configuration
Post-connect
Figure 3-44. Post-connect Configuration Message
3-100
Configure your post-connect system as described in "Configuring a Post-
connect System" on page 3-101. Then launch your post-connect system as
described in "Launching Post-connect Systems" on page 3-102.

Setting NAC 800 Properties

Most NAC 800 properties are set by default. To change or set properties, you
must change the properties as described in "Changing Properties" on page 15-
12.
You must set the following properties for <product name variable> to com-
municate with your external post-connect server (see "Configuring the Post-
connect Server" on page A-1):
Compliance.ActiveMQJMSProvider.url=ssl\://0.0.0.0\:61616
■
■ Compliance.JMSProvider.UserName=<username>
■ Compliance.JMSProvider.Password=<password>
Where:
<username> is the user name you use to log in to the external post-connect
server.
<password> is the password you use to log in to the external post-connect
server.