Replacing The Hard Drive - Dell Latitude D600 User Manual

Hide thumbs Also See for Latitude D600:
Table of Contents

Advertisement

1 antenna connectors on card (2)
2 antenna cables (2)
 
11. Lower the Mini PCI card toward the inner tabs to approximately a 20-degree angle.
 
12. Continue lowering the Mini PCI card until it snaps into the inner tabs of the connector.
 
13. Replace the cover.
 Replacing the Hard Drive
 
NOTICE:
in
standby
 
NOTICE:
 
CAUTION:
 
CAUTION:
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
 
1. Ensure that the work surface is flat and clean to prevent scratching the computer cover.
 
2. Save and close any open files, exit any open programs, and shut down the computer.
 
3. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.
 
4. Remove all installed batteries, and disconnect the AC adapter cable and any external devices from the computer. Wait 5 seconds before proceeding.
 
5. Ground yourself by touching a metal connector on the back of the computer, and continue to do so periodically during this procedure.
 
6. Turn the computer over. Use a small screwdriver to loosen the captive hard drive screw.
Downloaded from
www.Manualslib.com
To prevent data loss, shut down your computer before removing the hard drive. Do not remove the hard drive while the computer is on,
mode, or in
hibernate
mode.
Hard drives are extremely fragile; even a slight bump can damage the drive.
If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
Before working inside your computer, read the safety instructions in your Product Information Guide.
manuals search engine

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents