Resetting - Mercedes-Benz C-Class Coupe Operator's Manual

Side windows
86
To interrupt convenience closing:
X
release the & button.
Using KEYLESS-GO
The KEYLESS-GO key must be outside the
vehicle. All the doors must be closed.
Touch recessed sensor surface : on the
X
door handle until the side windows and the
panorama roof with power tilt/sliding
panel are fully closed.
i
Make sure you only touch recessed
sensor surface :.
Make sure that all the side windows and the
X
panorama roof with power tilt/sliding
panel are closed.
Touch recessed sensor surface : on the
X
door handle again until the roller sunblind
of the panorama roof with power tilt/
sliding panel closes.
To interrupt convenience closing:
X
release recessed sensor surface : on the
door handle.
Resetting the side windows
You must reset each side window if a side
window can no longer be closed fully.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is
completely closed (
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch
X
on the door control panel until the side
window is completely closed (
Hold the switch for an additional second.
X
If the corresponding side window remains
X
closed after the button has been released,
the side window has been reset correctly.
If this is not the case, repeat the steps
above again.
Problems with the side windows
Problem: a side window cannot be closed
because it is blocked by objects, e.g.
leaves in the window guide.
Remove the objects.
X
Close the side window.
X
Problem: a side window cannot be closed
and you cannot see the cause.
G
WARNING
If you close a side window again immediately
after it has been blocked or reset, the side
window closes with increased or maximum
force. The reversing feature is then not active.
Parts of the body could be trapped in the
closing area in the process. This poses an
increased risk of injury or even fatal injury.
Make sure that no parts of the body are in the
closing area. To stop the closing process,
release the switch or push the switch again to
reopen the side window.
If a side window is obstructed during closing
and reopens again slightly:
Immediately after the window blocks, pull
X
the corresponding switch again until the
side window has closed.
The side window is closed with increased
force.
I n f o r m a t i o n P r o v i d e d b y :
page 84).
Y
page 84).
Y