Asus Q-Connector - Asus P6T6 WS Revolution User Manual

ASUS Q-Connector (system panel)
You can use the ASUS Q-Connector to connect/disconnect chassis front panel
cables in a few steps. Refer to the instructions below to install the ASUS
Q-Connector.
1. Connect the front panel cables to
the ASUS Q-Connector.
Refer to the labels on the
Q-Connector to know the detailed
pin definitions, then match them
to the respective front panel cable
labels.
The labels on the front panel cables
may vary depending on the chassis
model.
2. Install the ASUS Q-Connector
to the system panel connector,
making sure the orientation
matches the labels on the
motherboard.
3. The front panel functions are now
enabled. The figure shows the
Q-Connector properly installed on
the motherboard.
2-34 Chapter 2: Hardware information