Selecting An Am Interval Spacing; Changing The Color System - JVC GVT0144-005A Instructions Manual

Connecting up
Connecting with TV
Supplied composite video cord
Main unit
COMPONENT VIDEO
Y P P
B R
S-VIDEO
VIDEO OUT
CAUTION
Connect the main unit directly with a TV (or a
monitor) without routing through a VCR.
Otherwise it may cause picture distortion while
playing.
Main unit
Connecting directly
Also, when connecting the main unit to a TV with
a VCR built in, there may be picture distortion
while playing.
You can enjoy pictures of better quality using the
following cord instead of the supplied video cord.
Connecting by using the component video
cord
You can enjoy better quality pictures than when
using the S-Video cord.
Red
Blue
Green
Connecting by using the S-Video cord
Main unit S-Video cord (not
supplied)
COMPONENT VIDEO
Y P P
B R
S-VIDEO
VIDEO OUT
CAUTION
Use one of either the S-Video cord or the
component video cord. If both cords are used,
pictures may not be played properly.
TV
TV (or
monitor)
Component video cord
(not supplied)
COMPONENT
VIDEO
Y P P
B R
S-VIDEO
VIDEO OUT
Main unit
TV
NOTE
• In order to enjoy pictures with Progressive mode
(page 26), the TV is required to have Progressive
video input.
• If the component video input jacks of your TV are
BNC type, use a plug adapter (not supplied) to
convert the plugs.
Connecting the power cord
AC outlet
Supplied power cord
• Connect the power cord after all other
connections are complete.
• The standby indicator (on the front panel) will be
lit.
Selecting an AM interval
spacing
You can change the AM interval spacing.
Some countries space AM stations 9 kHz apart,
and some countries use 10 kHz spacing.
• Before doing the following procedure, select
AM as source, then turn off the unit.
• Use the buttons on the main unit.
To set the AM tuner to the 10 kHz spacing:
While holding ¢, press
STANDBY/ON
To set the AM tuner to the 9 kHz spacing:
While holding 4, press
STANDBY/ON
Changing the color
system
You can select the video output to match it to the color
system of your TV (PAL or NTSC).
1
Press and hold VFP for 4 seconds while the
system is turned off (on standby).
2
Press cursor 2/3 to select the video output.
3
Press ENTER to set the video output.
Getting started Connection
Main unit
.
.
11