Konica Minolta bizhub PRO950 Troubleshooting Manual page 36

bizhub PRO 950 Troubleshooting
Category : Engine firmware
Engine special firmware list(based on Ver.G00-20,21)
Special
ROM Ver. DL No.
1
GU0-20 DLBT0902423JP
2
3
4
GM2-20 DLBT0903116JP
5
6
7
GM4-21 DLBT0903476JP
8
9
10
*1: The content improved in No4/5/6 of Ver.GM2-20 is including them to Ver.GM4-21 too. because
these can not include them to Ver.G00-21.
Return to home
CSES
Changed the default setting of punch hole
setting.
- DipSW 24-2_0: Current setting.
- DipSW 24-2_1: When the punch hole part is
2/3 or 2/4, and punch function is never used,
the "Left of 3-Hole Punch" or "Left of 4-Hole
Punch" is selected.
Following fault was corrected, when key counter
is pulled out.
- DIPSW9-1=0(Ignore), The cue of Windows will
become off-line, if SNMP of driver is turned ON.
- DIPSW9-1=1(Stop printing), The machine
becomes unable to receive any print jobs and
the data LED stays blinking.
The MFP that equips the modem for CSRC may
fail to recognize its finisher when it is returned
from the power save mode.
Mixed paper size printing for the Program Job.
Bundling jobs for stapling in the Program Job.
Bundling "file combination" jobs in HDD for
stapling.
When outputting a program job requires paper
feeding from bypass tray, the machine may stop
with the original check message displayed on the
operation panel.
*1:Mixed paper size printing for the Program Job.
*1:Bundling jobs for stapling in the Program Job.
*1:Bundling "file combination" jobs in HDD for
stapling.
Date of issue: Dec. 2009
Item
34/48
No EF1
Return to home
Based
DIPSW
version
24-2=1
G00-20
－
－
－
GU0-20
－
－
－
G00-21
－
－
－