Lace Designs; Quilting Designs - Janome Horizon Memory Craft 12000 Instruction Manual

Janome 12000 Sewing Machine Instruction Manual
www.janomeflyer.com

Lace designs

You can make a free standing lace by sewing the lace
designs on a tulle or other sheer net.
Attach a water soluble stabilizer to a tulle, more than one
layer may be required.
Use the same thread for the bobbin as the needle thread.
Adjust the embroidery foot height to 2 mm or higher (refer
to page 128).
Set the sewing speed to 600 spm or less (refer to page
129).
Select the desired lace design pattern and sew.
Remove the tulle from the hoop.
Trim away the tulle and stabilizer surrounding the design
pattern with scissors.
Rinse away the stabilizer using water.
Iron press the design pattern as necessary.

Quilting designs

Use the same thread for the bobbin as the needle thread.
The quilting designs SQ14-1 through SQ14-24 comprise
3 color sections.
However you do not need to change the thread color
since this is for sewing a specific section only.
You can select the specific section by pressing the next
page key.
Adjust the foot height if necessary (refer to page 128).
Turn on the one stitch stop function in the embroidery
setting mode (refer to page 128).
When pressing the start/stop button, the machine sews
one stitch and stops automatically.
Pull the needle thread to bring the bobbin thread up and
place both threads on the thread holder.
Sew several stitches and stop the machine.
Cut the loose threads close to the beginning of the stitch.
Start the machine again to sew the design pattern.
12000 Owners Manual/ User Guide
117