Input Level (L1 / L2 / L3); Audio Out Settings; Digital Out; Dolby Digital Out - Pioneer DVR-520H Operating Instructions Manual

The Initial Setup menu

Input Level (L1 / L2 / L3)

• Default setting: 0dB
Initial Setup
Basic NICAM Select
Tuner Tuner Level
Video In/Out External Audio
Audio In Bilingual Recording
Audio Out DV Input
Language Input Level (L1)
Recording Input Level (L2)
Playback Input Level (L3)
You can adjust the gain of the audio from each external
input individually, from –6dB to +6dB in steps of 3 dB to
optimize the recorded audio level.

Audio Out settings

Digital Out

• Default setting: On
Initial Setup
Basic Digital Out
Tuner

Dolby Digital Out

Video In/Out

DTS Out

Audio In

96kHz PCM Out

Audio Out MPEG Out
Language
Recording
Playback
If at any time you need to switch off the digital audio
output, set this to Off, otherwise leave it On.
Note
• When set to Off, all the other Audio Out settings are
grayed out and can't be set.
Dolby Digital Out
You only need to make this setting if you connected this
recorder to an AV amp/receiver (or other component) using
the digital output.
• Default setting: Dolby Digital
Initial Setup
Basic Digital Out
Tuner Dolby Digital Out
Video In/Out DTS Out
Audio In 96kHz PCM Out
Audio Out MPEG Out
Language
Recording
Playback
+6dB
+3dB
0dB
– 3dB
– 6dB
On
Off
Dolby Digital
Dolby Digital PCM
If your AV amp/receiver (or other connected component)
is Dolby Digital compatible, set to Dolby Digital,
otherwise set to Dolby Digital
manual that came with the connected component if
you're unsure whether it is Dolby Digital compatible.
DTS Out
You only need to make this setting if you connected this
recorder to an AV amp/receiver (or other component) using
the digital output.
• Default setting: On
Initial Setup
Basic Digital Out
Tuner Dolby Digital Out
Video In/Out DTS Out
Audio In 96kHz PCM Out
Audio Out MPEG Out
Language
Recording
Playback
If your AV amp/receiver (or other connected component)
has a built-in DTS decoder, set to On, otherwise set to
Off. Check the manual that came with the connected
component if you're unsure whether it is DTS
compatible.
Important
• If you set to On with a non-DTS compatible amp/
receiver, noise will be output when you play a DTS
disc.
• When set to On, there is no analog audio output
when playing a DTS DVD-Video disc.
• When playing a DTS audio CD (even when DTS Out
is Off), noise is output from the analog outputs. Do
not play this through your amplifier and speakers.
• When playing a DTS audio CD, make sure that
Stereo is selected using the AUDIO button. See
Switching audio channels on page 43.
96kHz PCM Out
You only need to make this setting if you connected this
recorder to an AV amp/receiver (or other component) using
the digital output.
• Default setting: 96kHz
Initial Setup
Basic Digital Out
Tuner Dolby Digital Out
Video In/Out DTS Out
Audio In 96kHz PCM Out
Audio Out MPEG Out
Language
Recording
Playback
PCM. Check the
On
Off
48kHz
96kHz 48kHz
96kHz
13
101
En