Table of Contents
Advertisement
Connecting the Cable between Indoor Unit and Outdoor Unit
Connecting the Cable between Indoor Unit and Outdoor Unit
Connect the cable to the Indoor unit.
Connect the cable to the indoor unit by connecting the wires to the terminals on the control
board individually according to the outdoor unit connection. (Ensure that the color of the wires
of the outdoor unit and the terminal No. are the same as those of the indoor unit.)
The earth wire should be longer than the common wires.
The circuit diagram is not subject to change without notice.
When installing, refer to the electrical diagram behind the front panel of Indoor Unit.
The wiring for the outdoor unit can be found on the inside of the Outdoor Unit control cover.
CAUTION:
• The circuit diagram is not subject to change without notice.
• Be sure to connect wires according to the wiring diagram.
• Connect the wires firmly, so that not to be pulled out easily.
• Connect the wires according to color codes by referring to the wiring diagram.
CAUTION: Provide a circuit
breaker between power source
and the outdoor unit as shown
below.
CAUTION: The power cord connected to the outdoor unit should be complied
with the following specifications (UL recognized and CSA certified).
Line voltage (208~230V)
The power connecting cable connected to the indoor and outdoor unit
should be complied with the following specifications (UL recognized and CSA
certified).
Low voltage (below 40V)
14 Room Air Conditioner
Main power source
Air
Conditioner
AWG18
Circuit Breaker
Use a circuit breaker
or time delay fuse.
Advertisement
Table of Contents
