Important Information - Allpro ScanX Duo DVM Instruction Manual

CAUTIONS -
Completely clean and erase PSPs before taking X-ray exposure.
See the PLATE PREPARATION section of this manual.
Minimize exposing an X-ray exposed PSP to light.
Transfer the PSP into the Inlet slot quickly to minimize exposure to light.
Use care in handling PSPs - Avoid fingerprints and scratching
Refer to the instructions provided with the PSP package for further information
on handling.
Use of other manufacturer's imaging plates
Do not put PSPs designed for drum-type or other scanners in the ScanX. The
thickness (especially thicker ones) will damage the ScanX. PSPs from another
manufacturer may be used as long as the specifications are the same as those
for the ScanX PSPs.
General Notes.
 All instructions in this manual form an integral part of the unit. They must
be kept close to the unit and in readiness whenever required. Precise
observance of these instructions is a pre-condition for use of the unit for
the intended purpose and for its correct operation. This manual should
be passed on to any future purchaser or operator.
 Safety of the operator as well as trouble-free operation of the unit are only
ensured if use is made of original equipment parts. Moreover, use may
only be made of those accessories that are specified in the technical
documentation or that have been expressly approved and released by
Air Techniques for the intended purpose. Air Techniques cannot warranty
for the safety or proper functioning of this unit in the case where parts or
accessories are used that are not supplied by Air Techniques.
 There is no guarantee against damage arising where parts or accessories
are used that are not supplied by Air Techniques.
 Observe the usage and storage conditions.
 Appliances which accumulate condensation or become wet through a
change of temperature may only be operated after they are fully dry.
 Air Techniques regard themselves as being responsible for the equipment
with regard to safety, reliability and proper functioning only if assembly,
resetting, changes or modifications and repairs have been carried out by
an authorized dealer and if the equipment is used in conformity with the
instructions contained in this manual.
 The device conforms to the relevant safety standards valid at this time.
 Any reprinting of the technical documentation, in whole or in part, is subject
to prior written approval by Air Techniques.

IMPORTANT INFORMATION

7
SAFETY NOTICE