Power Cord And Strain Relief Installation; Conduit And Squeeze Connector Installation - GE JSS28 Installation Instructions Manual

POWER CORD AND STRAIN
1
RELIEF INSTALLATION
• For power cord installations only (see the
next step if using conduit), assemble the
strain relief in the hole. Insert the power
cord through the strain relief and tighten.
Allow enough slack to easily attach the cord
terminals to the terminal block. If tabs are
present at the end of the winged strain
relief, they can be removed for better fit.
NOTE: Do not install the power cord
without a strain relief. The strain relief
bracket should be installed before
reinstalling the rear range wiring cover.
Strain relief
Power cord
Skip to applicable power cord installation.
Installation Instructions
Terminal
block
Bracket
7 7
CONDUIT AND SQUEEZE
2
CONNECTOR INSTALLATION
• For conduit installations only, purchase a
squeeze connector matching the diameter
of your conduit and assemble it in the hole.
Insert the conduit through the squeeze
connector and tighten. Allow enough slack
to easily attach the wires to the terminal
block.
NOTE: Do not install the conduit without a
squeeze connector. The squeeze connector
should be installed before reinstalling the
rear range wiring cover.
Squeeze
connector
Conduit
Skip to applicable conduit installation.
Terminal
block
Bracket