2. Position the interposer card in the server and attach it with the two mounting
3. Slide the CD-RW/DVD drive cable retainer toward the interposer card, so that it
4. Install the CD-RW/DVD drive (see "Installing the CD-RW/DVD drive" on page
5. Close the fan door.
6. Slide the server into the rack.
7. Reconnect the power cords and any cables that were removed.
8. Turn on the peripheral devices and the server.
Removing a memory module (DIMM)
To remove a DIMM, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cord and
78
IBM System x3350 Type 4192 and 4193: Problem Determination and Service Guide
screws that you removed previously
locks the CD-RW/DVD connector in place against the card.
CD-RW/DVD drive
cable retainer
73).
on page 57.
all external cables.
Mounting screws
Interposer card
CD-RW/DVD drive