Usb Support And Functionality - HP ProLiant ML370 Generation 5 User Manual

Access to redundant ROM settings
To access the redundant ROM through RBSU:
Access RBSU by pressing the F9 key during powerup when the prompt is displayed in the upper
1.
right corner of the screen.
Select Advanced Options.
2.
Select Redundant ROM Selection.
3.
Select the ROM version.
4.
Press the Enter key.
5.
Press the Esc key to exit the current menu or press the F10 key to exit RBSU. The server restarts
6.
automatically.
To access the redundant ROM manually:
Power down the server (on page 20).
1.
Remove the access panel (on page 25).
2.
Set positions 1, 5, and 6 of the system maintenance switch to On.
3.
Install the access panel (on page 26).
4.
Power up the server (on page 20).
5.
Wait for the server to emit two beeps.
6.
Repeat steps 1 and 2.
7.
Set positions 1, 5, and 6 of the system maintenance switch to Off.
8.
Repeat steps 4 and 5.
9.
When the server boots, the system identifies whether the current ROM bank is corrupt. If a corrupt ROM is
detected, the system boots from the backup ROM and alerts you through POST or IML that the ROM bank
is corrupt.
If both the current and backup versions of the ROM are corrupt, the server automatically enters ROMPaq
disaster recovery mode.

USB support and functionality

USB support (on page 89)
Internal USB functionality (on page 90)
USB support
HP provides both standard USB support and legacy USB support. Standard support is provided by the
operating system through the appropriate USB device drivers. HP provides support for USB devices before
the operating system loads through legacy USB support, which is enabled by default in the system ROM.
HP hardware supports USB version 1.1 or 2.0, depending on the version of the hardware.
Legacy USB support provides USB functionality in environments where USB support is normally not
available. Specifically, HP provides legacy USB functionality for:
•
POST
•
RBSU
Configuration and utilities 89