Slide the hard drive cage into the drive bay and insert the four screws to secure the drive cage to the
9.
chassis.
Connect the two SAS-SATA data cables to the drive cage backplane.
10.
IMPORTANT:
When installing a x3/x1 SAS cable, HP recommends that the x3 part of the
x3/x1 cable be linked to the SAS hard drive backplane connector that corresponds to hard
drive slots 1 to 4. In this setup, hard drive slot 1 will not be available, but since hard drive slots
2 to 4 will be connected, one continuous volume can be created.
Connect the 10-pin power cable to the drive cage backplane.
11.
NOTE:
The center wall is removed for illustration purposes only.
Hardware options installation 54