Panasonic KX-NS1000 Manual page 449

b.
Day/Night/Lunch button
c.
Day/Night/Break button
d.
Day/Night/Lunch/Break button
Each of these buttons is used for switching between modes. For example, pressing the Day/Night button
switches between day and night modes. All of these buttons show the current status as follows:
Light Pattern
Off
Red on
Green on
Slow green flashing
Slow red flashing
Note
Any extension user (except extension users allowed to change the mode) can only check the current
status on the display by pressing the Time Service button.
Conditions
•
System programming can set the following time periods:
–
Day-1 (Day Start time)
–
Lunch (Lunch Start time)
–
Day-2 (Lunch End time)
–
Night (Night Start time)
–
Break-1 Start
–
Break-1 End (Day restart)
–
Break-2 Start
–
Break-2 End (Day restart)
–
Break-3 Start
–
Break-3 End (Day restart)
•
One-look Networking (® 4.2 One-look Networking)
In Automatic Switching mode, system programming specifies which PBX's clock is used to determine the
time mode when a time-mode-dependent feature is used. One of the following 2 options can be specified:
–
The local PBX of the device or trunk that is using the feature
–
The PBX site to which the Time Table's tenant is assigned
® 14.6 PBX Configuration—[6-6] Feature—Tenant—
•
Time Service Switching Mode (Automatic/Manual) Button
A flexible button can be customised as the Time Service Switching Mode (Automatic/Manual) button.
PC Programming Manual References
10.4 PBX Configuration—[2-4] System—Week Table
10.5 PBX Configuration—[2-5] System—Holiday Table
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—
Lunch / Break / Night) Switch
10.7.1 PBX Configuration—[2-7-1] System—Class of Service—COS Settings—Manager—
Switch
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
Status
Day mode
Night mode
Lunch mode
Break mode
Holiday mode
Time Service Mode
5.1.4 Time Service
Time Service (Day /
Time Service
Feature Guide 449