Pioneer VSX-39TX Service Manual page 117

7 MASTER VOLUME buttons
Use to raise or lower the volume of the
receiver.
8 INPUT ATT button (when USE mode is
selected)
Use to lower the input level of an analog signal that is
too powerful, thus causing the sound to distort (the
OVERLOAD indicator will light).
REMOTE SETUP button (when SETUP mode
is selected)
Use to customize the remote control functions and the
remote control itself. (See "Setting Up the Remote
Control to Control Other Components" starting on ,
"Multi Operation" starting on )
MENU button
Use to get the various menus for your TV or DTV.
MUTING button
Press to mute or restore the volume.
EFFECT/CH SEL (when USE mode is selected)
button
EFFECT – Use these buttons to increase or decrease
the amount of effect applied in a DSP or Advanced
Theater mode. When the amount of effect is increased
in a DSP/Advanced Theater mode the characteristics of
that mode become stronger and more noticeable. The
scale ranges from 10-90 with 70 as the default setting.
First turn on the DSP/Advanced Theater you want (by
pressing the DSP/Advanced Theater button until you
get the mode) and then increase or decrease the
amount of effect.
CH SEL – You may want to adjust the channels when
listening to some sound sources. Use this button to
select the channel you want to adjust.
SYSTEM SET UP button (when SETUP mode
is selected)
Use to set up the speaker and sound systems. For
more information see "Setting up for Surround Sound"
starting on .
FUNCTION button
Press to select a source. The button will cycle through
all the possible sources.
5(+)/∞(–)/2/3/ENTER buttons
Use to operate the on-screen menu on your TV screen
and enter commands when setting up surround
sound, speakers levels & settings, and other set up
features . Specific use of these buttons is described in
conjunction with the operations they perform. For
more information see each individual section.
VSX-39TX, VSX-37TX, VSX-36TX, VSX-D909S
DIGITAL NR button
Press to switch Digital NR on or off.
SIGNAL SELECT button
Press SIGNAL SELECT repeatedly to select one of the
following:
ANALOG – Analog signal.
DIGITAL – Digital signal (DVD/LD, TV/SAT, CD, MD/TAPE
1/CD-R, VCR 1/DVR, VCR 2).
AC-3 RF (VSX-37TX only) –
SAT, VCR 1, VCR 2).
AUTO – This is the default. If there are both analog,
digital, RF input signals, the receiver automatically
selects the best possible signal.
9 MIDNIGHT button
Switches the MIDNIGHT mode on or off.
MULTI CH INPUT button
Press to switch to MULTI CH IN mode.
DSP button
Press repeatedly to select a DSP sound mode.
STEREO/DIRECT button
Switches the receiver into STEREO mode if it was in a
different sound mode (like ADVANCED THEATER) or
toggles between DIRECT and STEREO mode. For more
on STEREO mode .
DIRECT playback bypasses the tone controls and
channel level for the most accurate reproduction of a
program source.
LIGHT button
Press to light the remote control buttons.
/DTS buttons
Press these buttons to put the receiver in the selected
sound mode. For more information on the sound
modes.
RF signal (DVD/LD, TV/
117