Alarm Function - JVC CA-D672TR Instructions Manual

2. Preset stations are being searched for and while preparing to change the station, sound will be
muted.
3. The station will be changed and the programme type being received will appear on the display.
When using the DISPLAY MODE button to change the display, use the appropriate setting
for the type of display.
Notes:
• EON broadcasts of some stations may not be compatible with this Unit. In the case of an
incompatible EON broadcast, "EON" will not appear on the display.
• While the Unit is receiving information for an EON code you have selected for EON Standby,
you cannot use the following operations: MULTI CONTROL stick, TA/NEWS/INFO button or
PTY SEARCH button. In addition, if a station transmits information for a programme type you
have selected without sending the EON code, the EON Standby operation is still performed.
Therefore, you will not be able to use the operations listed above during this period.
• If the reception is unsatisfactory for a station among the preset stations, "WAITING" appears on
the display and the station is searched for again. If after searching through the channels five
times, the broadcasting station cannot be found, "NOT" and "FOUND" are displayed alternately
on the display. The Unit will then return to the station to which it was previously tuned.
When broadcasting of the desired information has been completed, "EON END" will be indicated
and the Unit will automatically go back to the station which had previously been tuned to.
While receiving information on EON Standby reception, the station will not change to other
stations even if the same information is available from them.
If you cancel the EON function when in EON Standby reception mode by either pressing the
EON ON/OFF button, the Unit will automatically return to the station which had been previ-
ously tuned-in.
If the information you are waiting for is available from the current station, the indicator will blink.
ALARM function —————————————————————————
If an ALARM (Emergency) signal is received while receiving an EON code from a station,
"ALARM" blinks on the display and the Unit automatically switches to the station broadcasting the
ALARM signal.
When an ALARM broadcast of PTY is being received from the currently tuned-in station,
"ALARM" will blink on the display for your attention.
1 2 3 4
5 6 7 8
EON [ TA NEWS INFO ]
9 10 11 12
TUNED
SOUND
STEREO
MODE
13 14 15 16
AUTO
Blinking
1 2 3 4
5 6 7 8
EON [ TA NEWS INFO ]
9 10 11 12
TUNED
SOUND
STEREO
MODE
13 14 15 16
AUTO
Blinking
TUNER
VOL
TUNER
VOL
17