Panasonic QUASAR PV-C1320 Service Manual page 32

PVQ-1310 / PV-C1320 / PV-C1330W / VV-1300 / VV-1310W / PV-C1340 / PV-C1350W / PV-C2010 / PV-C2020 / PV-C2030W / VV-2000 / PV-C2060
3. Holes on Main Cam Gear
a. The EJECT mode Hole on Main Cam Gear should be a
Through Hole with Hole A on Support Angle in EJECT
mode. The each mode Hole on Main Cam Gear should
be a Through Hole with Hole B on Support Angle in
each mode.
4. Main Cam Gear Kit
a. Main Cam Gear is supplied as a Main Cam Gear Kit
only (Kit No. VVGS0009).
Main Cam Gear Kit consists of a Main Cam Gear and a
Main Cam Push Nut.
However, Main Cam Push Nut is available separately as
a replacement part.
5. Installation of Main Cam Gear and Main Cam Push Nut
a. After installing the Support Angle, install the Main Cam
Push Nut with Needlenose Pliers etc. so that it is flush
with the chassis.
There may be some slight scratches on the Shaft of
Main Cam Gear, when removing the Main Cam Gear. In
case that the Main Cam Gear can be installed securely
without tottering, it is fine to use the one. If any tottering,
install all new parts.
Fig. J3-4
Fig. J3-5
6. The Main Cam Push Nut is not reusable. Install a new one.
32
Fig. J3-6