Panasonic QUASAR PV-C1320 Service Manual page 31

6.2.5. Capstan Belt, Support Angle,
Intermediate Gear B, and Main
Cam Gear
Fig. J3-1
PVQ-1310 / PV-C1320 / PV-C1330W / VV-1300 / VV-1310W / PV-C1340 / PV-C1350W / PV-C2010 / PV-C2020 / PV-C2030W / VV-2000 / PV-C2060
6.2.5.1. Reassembly Notes
1. Alignment of Main Cam Gear, Drive Rack Arm, and
Main Rod
a. Confirm that the hole on Main Rod is a Through Hole
with a hole on chassis.
b. Confirm that the hole on Drive Rack Arm is a Through
Hole with a hole on chassis.
c. Install the Main Cam Gear so that the projection of Main
Cam Gear is in the upward position as shown.
2. Confirmation/Alignment of Intermediate Gear B, Main
Cam Gear, and Intermediate Gear A
a. Confirm that the Hole A on Lift Gear is a Through Hole
with a hole on chassis.
b. Confirm that the hole on Intermediate Gear A is aligned
with the hole on Lift Gear.
c. Install the Intermediate Gear B so that the hole on the
Intermediate Gear B is aligned with the hole on the Main
Cam Gear.
31
Fig. J3-2
Fig. J3-3