Figure 64 - Optional Post Disarm Configuration - Motorola PTP 300 Series User Manual

7 Web Page Reference
When Section 7.7.5 "Installation Wizard Step 3 - Confirm Configuration" is complete, the
installation is armed and rebooted. Pressing the "Disarm Installation Agent" button completes
the installation process and the audible installation tone will be switched off. If the installer
wishes to modify the installation configuration then the 'Back' link can be used to access the
installation wizard steps described above.
The installation process is completed when both ends of the link are 'disarmed'.
After disarming the wireless link, the user is presented with message as shown in Figure 64.
This message has been obtained when configuring the link with a Region Code where
maximum power is used (Region Code of 1 and power of 27 dBm). The unit shows that the
Transmit Power has been reduced to the lower operating power band. The screen presents
hyperlinks to the main configuration and spectrum management pages.

Figure 64 - Optional Post Disarm Configuration

After installation the system administrator may wish to modify the wireless units descriptive
configuration (link name and link location). In addition the system administrator may wish to
change the spectrum management configuration of the wireless unit, or look at the analysis of
the 5.8 GHz spectrum to see if the automatic channel selection is appropriate for the system
administrator's network. It is also recommended that a backup copy of the wireless units
configuration is taken. Hyperlinks are provided on the post disarm page for ease of use.
119
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299