Figure 74 - Optional Post Disarm Configuration 1; Figure 75 - Optional Post Disarm Configuration 2 - Motorola PTP 600 Series User Manual

When Section 8.3.4.5 "Confirm Configuration" is complete, the installation is armed and
rebooted. Pressing the "Disarm Installation Agent" button completes the installation process
and the audible installation tone will be switched off. If the installer wishes to modify the
installation configuration then the 'Back' link can be used to access the installation wizard
steps described above.
The installation process is completed when both ends of the link are 'disarmed'.
After disarming the wireless link the user is presented with one of two possible configuration
pages, see Figure 74 and Figure 75. The screen presents hyperlinks to the main
configuration and spectrum management pages.

Figure 74 - Optional Post Disarm Configuration 1

Figure 75 - Optional Post Disarm Configuration 2

After installation the system administrator may wish to modify the wireless units descriptive
configuration (link name and link location). In addition the system administrator may wish to
change the spectrum management configuration of the wireless unit, or look at the analysis of
the 5.8 GHz spectrum to see if the automatic channel selection is appropriate for the system
administrator's network. It is also recommended that a backup copy of the wireless units
configuration is taken. Hyperlinks are provided on the post disarm page for ease of use.
166
8 Web Page Reference