Basic And Common Operations; Setting The Clock - JVC 0803AIMMDWJEM Instructions Manual

Basic and Common Operations

Setting the Clock

Before operating the unit any further, first set the built-in
clock. When you plug in the power cord, "0:00" starts
flashing on the display.
You can set the clock when the unit is either turned on or on
standby (off). You cannot set the clock if the unit is on Power
Save mode (see page 10).
On the remote control ONLY:
1
Press CLOCK/TIMER.
The hour digit starts flashing on the display.
2
Press ¢ or 4 repeatedly
to adjust the hour, then
press SET.
The minute digits start flashing on
the display.
• Each time you press ¢ or 4, the hour
digit(s) change(s) continuously.
• If you want to correct the hour again, press
CANCEL. The hour digit(s) start(s) flashing again.
3
Press ¢ or 4 to adjust the minute, then
press SET.
The built-in clock starts.
• Each time you press ¢ or 4, the minute digits
change continuously.
• Adjusting the hour and minute using the number buttons in steps 2
and 3
Ex.: To adjust the hour/minute to 5, press 5.
To adjust the hour/minute to 12, press +10, then 2.
To adjust the hour/minute to 20, press +10, then 10 (or press +10
twice, then 0).
• When you unplug the power cord or if a power failure occurs
The clock is reset to "0:00" right away. If this happens, set the clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
9
To change the clock again
On the remote control ONLY:
Press CLOCK/TIMER repeatedly until the
clock setting screen appears on the display.
The hour digit starts flashing. Then, perform
steps 2 and 3 in "Setting the Clock" again.
To check the clock time with tones
CLOCK/
TIMER
When the key-touch tone is activated (see "Turning On/Off
the Key-touch Tone" on page 10), the unit lets you know the
time using long and short tones in different pitches ONLY
while the unit is on standby (off).
On the remote control ONLY:
GROUP SKIP GROUP SKIP
Press DIMMER while the unit is on standby
(off).
"DIMMER OFF" appears, then the clock time
is shown on the display with tones.
The time is represented by a four-digit number: two digits
each for hours and minutes (ex. 2:58 = 0258).
Each digit is distinguished by a different pitch of tone, and
SET
numbers are made up of long and short tones.
The following shows the details.
Differentiation of digits:
Higher hours digit
Representation of numbers:
Numbers
Tones
Numbers
Tones
* •••••: Five quick short tones
Ex.:
Do Mi Sol
Higher minutes digit
Lower hours digit
0 1 2
— - --
5 6 7
••••• •••••- •••••-- •••••--- •••••----
Hours
—
--
Do Mi
CLOCK/
TIMER
DIMMER
Do
Lower minutes digit
3 4
--- ----
8 9
Minutes
••••• •••••---
Sol Do