Step 23: Replace Toekick; Step 24: Check The Following - GE Built-In Dishwasher Installation Instructions Manual

Dishwasher Installation

STEP 23: REPLACE TOEKICK

• Place toekick against the pre-toekick (on some models) and
legs of the dishwasher.
Attachment
Figure AH
• Align the toekick with the bottom edge and make sure it is
• Insert and tighten the 2 toekick attachment screws. The
• When reinstalling the toe kick on models with a sound barrier,
ensure that the bottom edge of the rubberized flap is flush
with the floor. Any excess material should be tucked up
behind the outer door. Do not allow excess rubberized flap to
lay on the floor. If any excess is not tucked completely behind
the outer door, it will bunch up between the door and toe kick
and impede proper opening and closing of the door. This will
be noticeable because the door will not stay fully open and
will spring up.
Tip: Reduce sound from under the dishwasher. Make sure
toekick is against floor.

STEP 24: CHECK THE FOLLOWING

• Tub trim does not interfere with the door
• Dishwasher is square and level at both the top and bottom of
the cabinet opening, with no twisting or distortion of the tub
or door
• Drain hose is not pinched between the dishwasher and
STEP 25: LITERATURE
• Be sure to leave complete literature package, these
Installation Instructions and product samples and/or coupons
with the consumer.
T o e k i c k
Screws
15