Step 16: Connect Water Supply - GE Built-In Dishwasher Installation Instructions Manual

Dishwasher Installation
STEP 15: POSITION DISHWASHER, SECURE
TO COUNTERTOP OR CABINET
In this step you will need the 2 Phillips special head screws
from the screws set aside in Step 1.
The dishwasher must be secured to the countertop or the
cabinet sides. When the underside of the countertop is wood,
use Method 1. Use Method 2 when the underside of the
countertop is made of a material, such as granite, that will not
accept wood screws.
IMPORTANT –
panel damage. Dishwasher must be positioned so the front
or countertop. Mounting screws must be driven straight and
flush. Protruding screw heads could scratch the door panel or
control panel and interfere with door operation.
Method 1
Secure dishwasher to underside of wood countertop.
• Recheck alignment of the dishwasher in the cabinet. Refer to
Steps 13 and 14. Door panel and/or control panel must not
hit cabinets or countertop.
• Fasten the dishwasher to the underside of the countertop
panel damage.
• Install plug buttons to the side of the tub well in the holes
provided.
Brackets
Prevent door panel and control
Wood Countertop
Method 2
Secure dishwasher to cabinet sides.
• Recheck alignment of the dishwasher in the cabinet. Refer
to Steps 13 and 14. Door panel and/or control panel must
not hit cabinets or countertop.
2 Phillips special head screws provided. Refer to Figure X.
panel damage. Do not screw into the cabinet face frame.
• Install plug buttons to the side of the tub well in the holes
provided.
Solid Surface Countertop
Granite Countertop
Side Brackets
Figure X
• Re-check that the dishwasher is squarely positioned in the
cabinet at both the top and bottom of the appliance after
• Confirm all leveling legs are in contact with the floor to
prevent the dishwasher from rocking and ensure proper door
and latch operation

STEP 16: CONNECT WATER SUPPLY

Connect water supply line to 90° elbow.
If using a flexible braided hose connection:
If using a copper tubing connection:
• Slide compression nut, then ferrule over end of water line.
• Insert water line into 90° elbow.
• Slide ferrule against elbow and secure with compression nut.
IMPORTANT –
water supply line.
Test by opening and
closing the door.
Reroute the water
supply lines if a
rubbing noise or
interference
occurs.
Figure Y
Bottom Left Side
Check to be sure that door spring
Hot Water
Supply Line
90° Elbow
Ferrule
Compression
Nut
11