Table of Contents
Advertisement
02 Locks and alarm
Remote key and key blade
Opening the remote key/PCC
Slide the spring loaded catch to the
02
side.
Pull the key blade straight out of the
remote key.
Insert a small screwdriver in the hole
behind the spring loaded catch and care-
fully pry up the cover.
NOTE
Turn the remote key with the buttons
upward so that the batteries do not fall out
when the cover is removed.
Replacing the batteries
CAUTION
When handling batteries, avoid touching
their contact surfaces as this could result in
poor battery function in the remote key.
Note the position of the battery's (+) or (–)
sides.
Remote key (one battery)
1. Use a screwdriver to pry out the old bat-
tery.
2. Insert a new one with the (+) side down-
ward.
58
PCC (two batteries)
1. Use a screwdriver to pry out the old bat-
teries.
2. Insert the first new battery with the (+) side
upward.
3. Insert the plastic spacer over the battery.
Insert the second new battery on top of the
plastic spacer, with the + side downward.
Re-assembling the remote key
1. Press the remote key's cover into place.
2. Hold the remote key with the slot for the
key blade up.
3. Carefully slide the key blade into its groove.
4. Gently press the key blade in the groove
until it clicks into place.
Old batteries should be properly recycled.
I n f o r m a t i o n P r o v i d e d b y :
Advertisement
Table of Contents
