JVC RX-665VBK Instructions Manual page 37

5. Press Control 2 2 2 2 2 / 3 3 3 3 3 to select the center mode.
Each time you press the button, the center modes change
as follows:
WIDE NORMAL
WIDE Select this mode when the center speaker can reproduce the bass
better than the front speakers. All signals of the center channel are
output through the center speaker.
NORMAL Select this mode when the center speaker cannot reproduce the
bass better than the front speakers. The bass portions of the center
channel signals are output through the front speakers.
PHANTOM Select this mode when you do not use a center speaker. The center
speaker channel signals are output through the front speakers.
6. Press Control 5 5 5 5 5 / ∞ ∞ ∞ ∞ ∞ until "–DELAY +" appears on
the display.
7. Press Control 2 2 2 2 2 / 3 3 3 3 3 to adjust the delay time of the
rear speaker output.
Each time you press the button, the delay time changes
as follows:
DELAY 1 DELAY 2
DELAY 1 Select this when the distance from you to your rear speakers is
greater than that to the front speakers.
DELAY 2 Select this when the distance from you to your rear speakers is
almost equal to that to the front speakers.
DELAY 3 Select this when the distance from you to your rear speakers is less
than that to the front speakers.
8. Press Control 5 5 5 5 5 / ∞ ∞ ∞ ∞ ∞ until "TEST" appears on the
display, then press Control 2 2 2 2 2 / 3 3 3 3 3 to start checking
the speaker output balance.
"TEST" starts flashing on the display, and a test tone
comes out of the speakers in the following order:
Left front
speaker
speakers
PHANTOM
DELAY 3
Center Right front
speaker speaker
Rear
Continued to the next page.
Note:
When you have selected
"3CHLOGIC," you cannot select
"PHANTOM."
Note:
When you have selected
"3CHLOGIC" or "THEATER," you
cannot adjust the delay time.
Notes:
• No test tone comes out of the
rear speakers when you have
selected "3CHLOGIC."
• No test tone comes out of the
center speaker when you select
"PHANTOM" for the center
mode.
34