Pioneer PDP-502MX Service Manual page 80

PDP-502MX, PDP-502MXE
Control Panel
(for PDP-502MXE)
1 2
– +
R
SPEAKER IN
8 Ω – 16 Ω
AUDIO OUTPUT COMBINATION
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16 Ω.
2
AUDIO OUTPUT (Stereo mini jack)
Use to output the audio of the selected source
component connected to this unit to an AV amplifier or
similar component.
3
COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE
TERMINALS.
These terminals are used in the factory setup.
4
CONTROL IN/OUT
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables control
of this unit as a component in a system.
5
RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
6
AUDIO INPUT (Stereo mini jack)
Use to obtain sound when INPUT4 is selected.
Connect the audio output jack of components
connected to INPUT4 to this jack.
80
3 4 5
OUT IN OUT RS-232C
CONTROL
6 7
R – L
(INPUT 3)
(INPUT 4)
AUDIO INPUT
7
AUDIO INPUT (Pin jack)
Use to obtain sound when INPUT3 is selected.
Connect the audio output jack of components
connected to INPUT3 to these jacks.
NOTE: The left audio channel (L) jack is not compatible
with monaural input sources.
8
INPUT4
For connection of a personal computer (PC). Make sure
that the connection made corresponds to the format of
the signal output from the connected component. Use
the INPUT4 OUTPUT terminal to output the RGB signal
to an external monitor or other component.
Note: The RGB signal will not be output from the
INPUT4 OUTPUT terminal when the main power of this
unit is off or in standby mode.
8
ANALOG OUTPUT
R G B
( (
ANALOG
INPUT4
R G B