Pioneer PDP-502MX Service Manual page 78

PDP-502MX, PDP-502MXE
Control Panel
(for PDP-502MX)
On this unit there are 4 input system terminals and 2 output system terminals.
There are also CONTROL terminals for connection of PIONEER components with the Î mark.
1 2
– +
R
SPEAKER IN
8 Ω – 16 Ω
AUDIO OUTPUT COMBINATION
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16 Ω.
2
AUDIO OUTPUT (Stereo mini jack)
Use to output the audio of the selected source
component connected to this unit to an AV amplifier or
similar component.
3
COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE
TERMINALS.
These terminals are used in the factory setup.
4
CONTROL IN/OUT
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables control
of this unit as a component in a system.
5
RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
6
AUDIO INPUT (Stereo mini jack)
Use to obtain sound when INPUT3 or INPUT4 is
selected.
Connect the audio output jack of components
connected to INPUT3 or INPUT4 to this unit.
78
3 4 5
OUT IN OUT RS-232C
CONTROL
6 7
R – L
(INPUT 1/2)
(INPUT 3/4)
AUDIO INPUT
7
AUDIO INPUT (Pin jack)
Use to obtain sound when INPUT1 or INPUT2 is
selected.
Connect the audio output jack of components
connected to INPUT1 or INPUT2 to this unit.
NOTE: The left audio channel (L) jack is not compatible
with monaural input sources.
8
INPUT4
For connection of a personal computer (PC) or similar
component. Make sure that the connection made
corresponds to the format of the signal output from the
connected component.
Use the INPUT4 OUTPUT terminal to output the video
signal to an external monitor or other component.
Note: The video signal will not be output from the
INPUT4 OUTPUT terminal when the main power of this
unit is off or in standby mode.
8
ANALOG OUTPUT
R G B ( (
ANALOG
INPUT4
R G B