How To Remove The Coaxial Jumper; How To Attach The Coaxial Jumper; Removing The Bt Pcb And Bt Ant Pcb - Pioneer AVH-P5200BT Service Manual

5
When unplugging the Coaxial Jumper, make sure to use jig GGF1539.
If the antenna cable is directly unplugged without using jig GGF1539, you might damage your fingertip or fingernail.

How to Remove the Coaxial Jumper

- -
- - When unplugging Coaxial Jumper, hook the point of jig GGF1539 on the lid of Coaxial Jumper
- - and vertically draw out along with the engagement axis of connector.

How to Attach the Coaxial Jumper

- -
- - For inserting Coaxial Jumper, adjust cord assy with the engagement axis of connector and insert it as vertically
- - as possible.
- - Do not insert the Coaxial Jumper in extreme slant, as the connector might suffer damage.
Only BT model
Removing the BT PCB and BT ANT PCB (Fig.8)
- -
1 Straighten the tabs at two locations indicated
and then remove the BT PCB.
2 Disconnect the Cord Assy using GGF1539.
3
Remove the screw and then remove the
BT ANT PCB.
5
6
GGF1539
Coaxial Jumper
AVH-P5200BT/XNUC
6
7
Connector
1
1
BT PCB
3
BT ANT PCB
7
8
A
B
C
D
E
2
Fig.8
F
95
8