Ptp System Status; General Information - Redline Communications AN-50e User Manual

3.3.2

PTP System Status

Click System Status
statistics. The following screen appears only in PTP version 1.XX.

General information

System Name: Displays the user-assigned system name.
Software Version: (see System Information screen)
RF Link Established: Status for the wireless link connection.
Yes - RF link has been successfully established with the remote-end terminal.
No - RF link has not been established with the remote-end terminal.
Uncoded Burst Rate: The current uncoded burst rate for the link.
Master Mode: Displays if the system operation mode is set to Master.
RF Channel Frequency: Current channel selection.
Tx Power: Transmit power level.
Cable Attenuation: Displays the measured attenuation of the 800 MHz signal
over the IF cable.
Link Distance [Miles or Km]: Distance between master and slave systems.
RF Status [Error Code]: An error code indicating the condition of the system RF
components. See Table 27: Diag. - RF Status Error Codes on page 74 for details.
Ethernet MAC Address: System hardware address.
70-00033-01-03
in the menu to view system, Ethernet, and wireless interface
Proprietary Redline Communications © 2005
Page 33 of 100
AN-50e
user manual
September 2005