Lincoln Electric RANGER 250 GXT (AU) Operator's Manual page 14

A-8
AUXILIARY POWER WHILE WELDING
Simultaneous welding and power loads are permitted
by following Table I. The permissible currents shown
assume that current is being drawn from either recep-
tacle of 240V supply. Also, the "Output Control" is set
at "10" for maximum auxiliary power.
TABLE I
SIMULTANEOUS WELDING AND POWER
Output Selector Permissible Power
Setting Watts (Unity Power
Factor)
Max. Stick or Wire
Feed Setting None
180 Stick Setting 5100
130 Stick Setting 7200
No Welding 7200
*
Each receptacle is limited to 15 amps.
STANDBY POWER CONNECTIONS
The Ranger® 250 GXT (AU) is suitable for temporary,
standby or emergency power using the engine manu-
facturerʼs recommended maintenance schedule.
Tha Ranger® 250 GXT (AU) can be permanently
installed as a standby power unit for 240 volt (60Hz).
Connections must be made by a licensed electrician
who can determine how the 240 VAC power can be
adapted to the particular installation and comply with
all applicable electrical codes. The following informa-
tion can be used as a guide by the electrician for most
applications.
1. Install an isolation switch between the power com-
pany meter and the premises disconnect. (The
Ranger® 250 GXT (AU) and the power company
supplies must not be connected together).
Switch rating must be the same or greater than the
customerʼs premises disconnect and service over cur-
rent protection.
2. Take necessary steps to assure load is limited to
the capacity of the Ranger® 250 GXT (AU).
Loading above the rated output will reduce output
voltage below the allowable -10% of rated voltage
which may damage appliances or other motor-dri-
ven equipment and may result in overheating of the
Ranger® 250 GXT (AU) engine.
INSTALLATION
Permissible Auxiliary
Current in Amperes
*
240V
0
21
30
30
RANGER® 250 GXT (AU)
A-8