Table of Contents
Advertisement
14 in. 200-Sheet Paper Tray Top Cover
1. Push the tab where the left corner of the tray cover pivots.
2. Move the left tray cover pivot pin forward and then upward.
3. Remove the cover from the tray.
14 in. 500-Sheet Paper Tray Top Cover
1. Remove the two screws which secure the front trim panel.
2. Slide the trim panel to the rear to expose the tray cover pivot
pins.
3. Lift the cover from the tray.
Transfer Roll Removal
1. Unplug the power cord.
2. Remove the print cartridge.
3. Remove the bearing cover from the left side of the transfer roll:
Note: Do not touch the transfer roll surface.
•
Support the left bearing cover from the front with your left
hand.
•
Use a small screwdriver to push the rear latch forward and
release the bearing cover. This exposes the bearing on the
end of the transfer roll.
4. Grasp the bearing on the end of the transfer roll. Lift slightly and
move it to the left until the right end of the transfer roll shaft
slides out of the right side bearing.
5. Remove the transfer roll.
6. Lift the right bearing straight up and out of the machine.
Repair Information
65
Advertisement
Table of Contents
