Recording On An Md; Before You Start Recording On An Md - JVC UX-J99DVD Instructions Manual

Recording on an MD

Before You Start Recording on an MD

• It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.
• When you record onto partially recorded MD, its contents are not erased or overwritten. The recording starts from the point following
the last recorded track of the MD.
If you want to record on such an MD from the beginning, you have to erase its contents first (see "Erasing All Tracks
—ALL ERASE" on page 67).
• When an MD is fully recorded, recording will stops automatically.
• The recording level is automatically set correctly, so it is not affected by the volume level. Thus, during recording you can adjust the
sound you are actually listening to without affecting the recording level.
• While recording, you can hear sound mode effect and/or the AHB PRO (Active Hyper Bass PRO) effect through the speakers or
headphones. However, the sound is recorded without these effects (see pages 11 and 12).
• When selecting DISC or AUX-DIGITAL as the source, you can make a digital to digital recording.
When recording from a digital-copied CD-R/RW on an MD, see pages 47 and 88.
• You cannot record more than 254 tracks onto an MD, even if there is still enough recording time remaining on it.
About the track marks
When playing an MD, you can move among the tracks.
You can do this because there is a mark recorded at the beginning
of each track enabling you to locate the track. This mark is called
a "track mark" and the portion between two adjacent track marks
is called a "track."
• When using disc synchronized recording, a track mark is
recorded at the beginning of each track. You cannot put a track
mark manually.
• When recording from an analog source such as FM, AM,
TAPE, or AUX, you can select "MANUAL MARK," "TIME
AUTO MARK," and "AUTO TRK MARK" by pressing SET
(see page 49).
To add a track mark after recording is over, you can use the
DIVIDE function (see page 64).
45
To avoid erasing important recordings
The recordable MD has an erasure prevention tab so that
important recordings are not accidentally erased. When you
finish recording or editing, slide to open the erasure prevention
tab on the cartridge side surface. New recording or editing is now
no longer possible. (If you try to do, "DISC PROTECTED"
appears on the display.)
To do re-recording or editing, return the tab to the closed
position.
Erasure prevention tab
Recording/Editing Disc protected: Recording/
possible Editing not possible
If "PLAY BACK DISC" appears on the display
when you try to record on an MD
The MD is only for playback use, not for recording (see page 90).