Tank Unit - Husqvarna 362XP Workshop Manual

Cleaning and inspection
Clean all components and check that the fuel line is
undamaged.
Reassembly
1. If the chainsaw is equipped with hand grip heating, refit
the heating element into the rear hand grip, if it has been
removed. See pages 20 and 21.
2. If a new fuel hose is to be fitted, proceed as follows:
A. Lightly oil in one half of the new fuel hose.
B. Thread in the oiled part through the hole in the tank
unit. Allow 80-85 mm to protrude on the outside.
See fig. 4.
C. Twist the hose so that it is bent upwards. See fig. 4.
D. Cut off the angled ends of the hose so that it protrudes
70-75 mm on the outside.
E. Remove the hose from the tank and fit the fuel filter.
Push on the hose as far as it will go.
3. If the front hand grip has been removed, refit it. Tighten
the bolts to 4 Nm.
NOTE!
Ensure that the fuel hose and throttle cable
are not damaged.
4. If the throttle lock has been removed, it should be refitted
before the tank unit and motor unit are reassembled.
See page 15.
5. Lift the motor unit over the tank unit and push the fuel line
and throttle cable into their holes in the bottom of the
carburettor space.
6. Reconnect the leads to the stop switch.
7. Turn the tank unit a little towards the flywheel side so that
the fixed travel limiter is in the correct position.
8. Refit the bolt (F) on the flywheel side. See fig. 5. Tighten
to 6 Nm.
9. Fit the bolts (C and D), chain catcher and travel limiter bolt
(E) on the clutch side. See fig. 6. Tighten the bolts to the
torque shown on the diagram.
10.If the saw is equipped with hand grip heating, reconnect
the lead at C.
11. Reconnect the fuel line (B) to the carburettor. See fig. 7.
12.Insert the throttle cable outer into its location and reconnect
the throttle cable (A) to the carburettor. See fig. 7.
13.Refit the cylinder cover, chain and guide bar.
See instruction book.
36 – English

TANK UNIT

Fig. 4
Fig. 5
C, 4 Nm
E, 6 Nm
Fig. 6
A
Fig. 7
F
D, 6 Nm
B