Tank Unit - Husqvarna 362XP Workshop Manual

Tank unit

!
WARNING!
The fuel that is used in the chainsaw
poses the following hazards:
1. The fluid and its fumes are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.
Dismantling
1. Run off the fuel from the tank.
2. Remove the cylinder cover, chain and guide bar. See
instruction book.
3. Disconnect the throttle cable (A) from the carburettor and
push out the cable outer from its location. See fig. 1.
4. Remove the fuel pipe (B) from the carburettor.
5. If the saw is equipped with heated hand grips, disconnect
the lead at C.
6. Remove the bolts (C and D) and the travel limiter bolt (E)
on the clutch side. See fig. 2.
7. Remove the bolt (F) from the flywheel side. See fig. 3.
8. Lift the motor unit slightly and, using pliers, push off the
cable clips from their respective switches. If the saw is
equipped with hand grip heating, disconnect the leads
from on/off switch.
NOTE!
Take care that the fuel pipe and throttle cable
are not damaged.
9. Lift the motor unit and turn the tank unit slightly to the
flywheel side so that the fixed travel limiter comes free.
Lift off the tank unit.
10.If necessary, detach the front hand grip from the tank unit.
11. If necessary, lift out the fuel pipe and pull off the fuel filter.
Use tool 502 50 83-01, see item 22, page 7.
12.If the chainsaw is equipped with hand grip heating,
detach the connector to the heating element in the rear
hand grip.
See pages 20 and 21.
13.If the springs are to be removed, refer to AV-system,
page 37.
TANK UNIT
A
Fig. 1
C
E
Fig. 2
Fig. 3
B
D
F
English – 35