Wash Programmes - Indesit SIXL125SEU Service Information Manual

Indesit Company
PAUSING / RE-STARTING A PROGRAMME
To activate the washing machines "Pause" function press the programme button of the programme
in progress.
The Power On button remains lit, the LED of the programme in progress flashes slowly, and the
central ring of LEDs start to flash (depending how far the appliance is into its programme will depend
on how many central LEDs are lit).
To Re-start the programme after activating the Pause function, press the programme button once.
RE-SETTING A PROGRAMME IN PROGRESS
To reset a programme in progress, press and hold down the On / Off button for more than 2 seconds,
an audible sound will be heard. At this point the programme in progress will be cancelled and the
machine will switch off. (Approximately 1 - 2 minutes from power off the door lock will disengage.)
CAUTION: - Do not switch the appliance off during the drain cycle, as this will leave the water in the
drum potentially higher than the door seal lip depending on the programme.
NOTE: - BEFORE the machine switches off it will automatically run a drain cycle. This will happen
regardless if the appliance has water in it or not. During draining, the power on button will flash.
PROGRAMME PROGRESS
The inner ring of LEDs indicates the progress of the wash programme.
These start to light up in a clockwise direction, starting from the LED at the 12 O'clock position as
more LEDs light up, the previous ones remain lit.
AT THE END OF THE SELECTED PROGRAMME
When the wash programme ends, the Power On LED and the selected programme LED remain lit,
the inner ring of LEDs will begin to flash.

WASH PROGRAMMES

B utto n F abrics
WH ITE COTTON
Durable white cotton
COL OR M IX 40° / E AS Y IR ON
Coloured cotton
and synthetics
D EL ICATE S
W ool (final delicate spin
+
cycle)
+
Silk and curtains (withou t
final spin cycle)
DAILY WAS H / COL D WATER R IN S E
Cotton and synthetics
The duration of the programmes indicated in the table are for guidance purposes only, and are calculated based on an average load quantity.
Service Manual UK
M ax . S pin
lo ad Tem perature spee d
(kg) (rpm )
6 60°C 1400
4,5 40°C 1000
1,5 30°C 600
1,5 30°C no*
30°/cold
3 800
w ater**
9 of 28
Cycle
duration Wash cycle de scriptio n
(m inutes)
Wash cycle, rinse cycles, in termediate
145
145
and final spin cycles
Wash cycle, rinse cycles and delicate
105
spin cycle
Wash cycle, rinse cycles and delicate
50
spin cycle
50 Wash cycle, rinse cycles and drainage
Wash cycle (only if the " R apid w ash"
30 programme activated), rin se cycles,
delicate spin cycle
English