Table of Contents
Advertisement
Indesit
Company
PROGRAMMING (Using Smartcard Reader / Card)
If the Main Module has been replaced during a repair the board will require programming using the
following method.
1.
Do NOT connect the machine to electrical supply.
2.
Insert the pre-programmed card into the Card
reader. Care must be taken at this point to ensure
the card is inserted correctly with the Chip on the
card facing the PCB of the Reader.
3.
Insert the Reader & Card into module connection
port - see photo.
4.
Connect the machine to the Electrical
LED's on the Smart Card Reader will light in this
sequence:
a)
Red ON: Good Communication between Smart Card
Reader & Card.
b)
Red ON; Green Blinking: Download taking place.
c)
At end, Green ON ---> Download OK.
d)
At end, Red ON or RED Flashing ---> Download
NOT OK.
5.
Programming Complete, disconnect the machine
from Electrical supply.
6.
Remove the Smart Card Reader.
Service Manual UK
supply, the
20 of 28
Smart Card Reader
and Smart Card in use
English
Hide quick links:
Advertisement
Table of Contents
