Hard Top Enclosure - Regal 53 SC Owner's Manual

HARD TOP ENCLOSURE

The standard hard top enclosure features a sliding door and
opening window. The tempered glass is tinted and incased
within a tough aluminum extrusion to form a complete
weather-tight enclosure.
Aft Lower
Window
ENCLOSURE IN CLOSED POSITION
vent window down. Check to make sure it is latched. See
the illustration.
To open the lower aft enclosure window press and hold
the lower portion of the "window" marked switch located
at the port companionway entry way.
To close the lower aft enclosure window press and hold
the upper portion of the "window" marked switch located
at the port companionway entry way until the window unit
is raised to the top. This window uses an electric-hydraulic
cylinder to open and close.
Auxiliary Equipment Operation
Aft Vent Window
Door
To open the aft upper vent
window pull the latch to the
left until the window clears
the latch. The hydraulics will
pull the window up and lock
it in the open position.
To close the aft upper vent
window push in on the spilt
hydraulic casing and pull the
ENCLOSURE IN OPEN POSITION
The enclosure aft door features an easy slide track and
can be locked for extra security. Open the door until it
reaches the detent stop mechanism
resists rust and oxidation. Also, known as turbine oil it is
comparable to Regal R&O and Vitrea/Turbo.
ENCLOSURE VENT WINDOW HYDRAULIC
PUMP-ENGINE ROOM
47
Note that the hy-
draulic pump/circuit
board that operates
the aft enclosure vent
window is located in
the engine room on
the forward bulkhead.
If the window jerks
when moving up or
down it may be due
to air in the lines or a
lack of fl uid in the hy-
draulic lines or pump.
Fill the pump as
needed with utility
grade #22 hydraulic
oil. This is a machine
oil, non-detergent and
SAE 5 weight oil. It